How Much Does a Cold Plunge Cost to Run? Electricity, Filters and Ice (2026)
Updated · 8 min read · By Steve Gilman, Editor
We may earn a commission from links on this page, at no extra cost to you. Affiliate disclosure.

Key takeaways
- A chilled cold plunge usually costs somewhere between about $8 and $55 a month in electricity, depending far more on how many hours the chiller runs than on its horsepower.
- Filters are the cost most buyers forget. Depending on the brand and how often you change them, replacement cartridges can cost as much as the electricity, or more.
- Buying bagged ice for every session is almost always the most expensive way to plunge if you do it several times a week.
The short answer
For most homes, a cold plunge with a chiller costs roughly $8–$55 a month in electricity at today's average US power price, plus filters and sanitizer. A well-insulated tub kept indoors with the lid on sits at the low end. An uninsulated tub outdoors in summer sits at the high end.
If you skip the chiller and use ice instead, the electricity cost disappears, but the ice bill usually ends up far higher than a chiller's power bill once you plunge more than once or twice a week.
Want your own number? Use our cold plunge cost calculator. The rest of this guide explains where the money goes, so you can sanity-check the result.
How a chiller uses electricity
A cold plunge tub itself draws no power. Almost all of the electricity goes to the chiller (a small refrigeration unit) and the circulation pump that pushes water through it and the filter.
The math is simple:
Monthly cost = chiller watts × hours running per day × 30 days ÷ 1,000 × your price per kWh
The hard part is the middle number. A chiller doesn't run flat-out all day. Once the water reaches your set temperature, the compressor cycles on and off to hold it there. The Pod Company, for example, says its chillers' compressors typically run only 20–30 minutes each hour after the initial cool-down. How long yours runs depends on:
- Where the tub sits. A hot patio or sunny garage makes the chiller work much harder than a cool basement.
- Insulation and the lid. An insulated tub with the lid on loses cold slowly. An open or uninsulated tub doesn't.
- Your set temperature. Holding 39°F takes more work than holding 50°F.
- How often you use it. Every session warms the water a little and adds work.
What chillers actually draw
Horsepower describes cooling capacity, not your electricity use. The number that matters is the input power in watts on the spec sheet. A few published examples (checked November 16, 2026):
| Chiller size | Example published input power |
|---|---|
| 1/3 HP | 280 W (Titan and The Pod Company standard chillers) |
| 1/2 HP | 450–500 W (Penguin Chillers 1/2 HP; Titan Pro) |
| 0.8 HP | 680 W (Aleko 0.8 HP) |
| 1 HP | 750–850 W (Titan Pro+; Penguin Chillers 1 HP; Coldture Chiller Pro) |
Two units with the same horsepower can draw different wattages, so always check the model you're considering.
Three realistic electricity scenarios
These use the US average residential electricity price, which the Energy Information Administration reports at about 18 cents per kWh for the first five months of 2026. Your rate could be much lower or much higher, so check your bill.
| Scenario | Chiller | Hours running per day | Energy per month | Cost per month |
|---|---|---|---|---|
| Indoors, insulated tub, lid on | 500 W | ~3 h | ~45 kWh | ~$8 |
| Typical home setup | 500 W | ~8 h | ~120 kWh | ~$22 |
| Outdoors in hot weather, or poorly insulated | 850 W | ~12 h | ~306 kWh | ~$55 |
The first row lines up with what one manufacturer publishes for its 1/2 HP, 500 W chiller: 1.4–1.8 kWh per day in a 77°F room with the water set to 46°F. Treat any single number as a starting point. Your own setup is what decides it.
The costs people forget: filters and sanitizer
Most chilled plunges push water through a cartridge filter, and those cartridges get replaced on a schedule:
- Sun Home sells a 3-pack of its standard cold plunge filters for $49 and recommends replacing them every 2–4 weeks. That works out to roughly $17–$35 a month.
- Icetubs sells a 6-pack of its filters for $275 and recommends monthly replacement, which is about $46 a month.
(Prices checked November 16, 2026; they change.)
On top of that, many owners use a sanitizer (chlorine, bromine or a manufacturer-approved product), test strips and the occasional cleaner. Budget a few dollars to a few tens of dollars a month depending on the product and your water. Our guide to cold plunge water care covers what you actually need.
Bottom line: for many owners, filters and water care cost about as much as the electricity. Check the replacement filter price before you buy a plunge, not after.
What about ice?
An ice tub has no chiller and no power bill, which makes it the cheapest way to start. The catch is the ice.
How much you need depends on the tub size, your tap water temperature and how cold you want it. Garage Gym Reviews found the Ice Barrel needs at least 40 pounds of ice to reach proper plunge temperatures. A Gear Patrol tester bought 40–60 pounds of ice twice in one week to keep their barrel cold.
A worked example: 3 sessions a week × 50 lb per session ≈ 650 lb a month, or about 65 ten-pound bags. Multiply 65 by what a bag costs where you live. At $3 a bag, for example, that's about $195 a month, several times the electricity cost of even the hungriest chiller in the table above.
Ice still makes sense if you plunge occasionally, want to test the habit before spending thousands, or can make your own ice. If you plunge most days, a chiller usually pays for itself in running costs over time. See our cold plunge buying guide for the bigger trade-offs.
How to keep running costs down
- Keep the lid on. It's the single biggest efficiency lever, and it keeps debris out too.
- Choose a shaded, sheltered spot. Direct sun and hot garages make the chiller work hardest.
- Don't set it colder than you'll use. If you plunge at 48°F, holding the water at 39°F is wasted electricity.
- Insulate. An insulated tub costs less to run than a thin-walled one.
- Keep the filter clean. A clogged filter restricts flow and makes the system work harder.
- Check your utility's time-of-use rates. Some chillers can be scheduled to do most of their work overnight when power is cheaper.
How we got these numbers
We didn't measure a chiller ourselves. The figures above come from manufacturers' published specs, prices and recommendations, the EIA's average electricity price, and independent reviews, all cited below. The scenarios are our own estimates using that published data. Your actual cost depends on your chiller, climate, set temperature and rate.
Sources
- U.S. Energy Information Administration, Monthly Energy Review (Table 9.8, Average Prices of Electricity to Ultimate Customers)
- The Pod Company: Is the chiller going to run up my electricity bill?
- Titan Plunge: chiller power specifications
- Penguin Chillers 1 HP and 1/2 HP specifications (Recovery for Athletes)
- Aleko 0.8 HP cold plunge chiller specifications
- Coldture Chiller Pro specifications
- PlungeBox 1/2 HP Chiller Pro energy use (Recovery for Athletes)
- Sun Home cold plunge replacement filter (3-pack)
- Icetubs replacement filter 6-pack (Recovery for Athletes)
- Garage Gym Reviews: Ice Barrel review
- Gear Patrol: Ice Barrel review
- Penguin Chillers Cold Therapy Chiller overview (pump and power cycling)
Frequently asked questions
How much electricity does a cold plunge use per day?
Roughly 1.5 to 10 kWh a day for most home chillers. A well-insulated indoor tub with the lid on is at the low end; an uninsulated tub outdoors in hot weather is at the high end. Multiply your daily kWh by your electricity rate to get the cost.
Does a bigger chiller cost more to run?
Not necessarily. A larger chiller draws more watts while running, but it may reach your set temperature faster and run fewer hours. Insulation, location and set temperature usually matter more than horsepower.
Is it cheaper to use ice or a chiller?
For occasional use, ice is cheaper because there's nothing to buy upfront. For several sessions a week, bagged ice typically costs far more per month than a chiller's electricity.
Should I turn my chiller off between sessions?
Follow your manufacturer's instructions. Many systems are designed to run continuously so the water keeps circulating through the filter, and some manufacturers warn that frequent power cycling adds wear to the pump.
Does running a cold plunge in winter cost less?
Usually, if it's somewhere cool but above freezing, because the chiller has less heat to remove. Outdoors, freezing weather brings a different problem: most chillers must be drained before temperatures drop below 32°F. See our guide to cold plunging outdoors in winter.
Related articles
Cold Plunges · guide
Cold Plunge Buying Guide (2026): Chiller vs. Ice, Temperature, Size and Safety
Thinking about a home cold plunge? How to choose between a chiller and an ice tub, what temperature you actually need, what it costs, and how to stay safe.
10 min read
Cold Plunges · guide
How Often Should You Change Cold Plunge Water? A Simple Care Schedule
How often to change cold plunge water for ice tubs and filtered chillers, plus sanitizer, filter and testing basics, and the warning signs to drain early.
7 min read
Cold Plunges · guide
Using a Cold Plunge Outdoors in Winter: Freezing Temps, Chillers and Safety
Can you keep using an outdoor cold plunge in winter? What manufacturers say about freezing temperatures, how to winterize, and staying safe in the cold.
7 min read
Contrast Therapy · guide
How to Set Up Contrast Therapy at Home: Sauna + Cold Plunge Planning Guide
Planning a sauna and cold plunge at home? Layout, space, power, budget and a sensible beginner routine for home contrast therapy, plus the safety basics.
8 min read